<span id="5fxhx"><listing id="5fxhx"><meter id="5fxhx"></meter></listing></span>
<address id="5fxhx"><mark id="5fxhx"></mark></address>
    <menuitem id="5fxhx"><font id="5fxhx"></font></menuitem>

    <form id="5fxhx"></form>

    <strike id="5fxhx"><output id="5fxhx"></output></strike>

      <var id="5fxhx"><dfn id="5fxhx"></dfn></var>
      <ins id="5fxhx"><noframes id="5fxhx"><pre id="5fxhx"></pre>

      <menuitem id="5fxhx"></menuitem>

          <nobr id="5fxhx"><dfn id="5fxhx"><cite id="5fxhx"></cite></dfn></nobr>

          歡迎光臨 [ 無錫市駿德冶金設備有限公司 ] 官網!

          網站地圖 聯系我們

          無錫市駿德冶金設備有限公司

          銷售熱線

          138 0618 6056

          簡述軋輥鑲套的焊接方法

                 對接接頭環縫的焊接方法是制造圓筒形容器常用的一種焊接形式,一般先在軋輥鑲套對焊焊劑墊上焊接內環縫,然后再在滾輪轉胎上焊接外環縫。
                 環縫坡口采用不對稱布置,將主要焊接工作量放在外環縫,內環縫主要起封底作用。
                 環縫埋弧焊的焊接條件可以參照平板雙面對接的焊接條件選取,軋輥鑲套的焊接操作工藝也與平板對接時的基本相同。
                 為了不讓熔池中液態金屬和熔渣從轉動的焊件表面流失,無論焊接內環縫還是外環縫,焊絲位置都應逆焊件轉動方向偏離中間線要求距離,讓焊接熔池接近于水平位置,使得軋輥鑲套獲得較好成形。焊絲位置距離隨著所焊筒體直徑而變,一般為30~80mm。
          亚洲mv国产mv在线mv综合试看_亚洲A∨无码一区二区三区_91久久精品美女高潮喷水_中文字幕无码精品
          <span id="5fxhx"><listing id="5fxhx"><meter id="5fxhx"></meter></listing></span>
          <address id="5fxhx"><mark id="5fxhx"></mark></address>
            <menuitem id="5fxhx"><font id="5fxhx"></font></menuitem>

            <form id="5fxhx"></form>

            <strike id="5fxhx"><output id="5fxhx"></output></strike>

              <var id="5fxhx"><dfn id="5fxhx"></dfn></var>
              <ins id="5fxhx"><noframes id="5fxhx"><pre id="5fxhx"></pre>

              <menuitem id="5fxhx"></menuitem>

                  <nobr id="5fxhx"><dfn id="5fxhx"><cite id="5fxhx"></cite></dfn></nobr>